Hi guys,
I'm trying to configure a VPN from my home machine to my office network. Had this working previously, but since upgrading to Cisco RV130W I have been having issues configuring the connection.
Okay so I'm connecting with Shrew VPN Soft, I reach "tunnel enabled", but from there I cannot ping any devices on the office network. LAN and Internet access are fine. I don't get a local IP, so maybe I've misconfigured something?
Here's the Shrew log.
config loaded for site 'x.x.x.x'
attached to key daemon ...
peer configured
iskamp proposal configured
esp proposal configured
client configured
local id configured
remote id configured
pre-shared key configured
bringing up tunnel ...
network device configured
tunnel enabled
Previously I used Cisco VPN Connect and that was quite simple to configure, but that doesn't seem to work either.
Some guidance would be greatly appreciated.
J
