- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
10-28-2013 01:22 AM - edited 11-18-2020 03:04 AM
NEW December 21
Final Image 7.4.121.0 is now posted to CCO, thanks for all your feedback
Issues fixed on this release
CSCul58609 | Dataplane crash nbar timer wheel corrupt and Heartbeat miss |
CSCul77973 | Upgrade from 7.6 to 8.0 with existing AVC prof client traffic fails |
CSCul94742 | controller crash with memory corruption |
CSCuj12935 | wism2 hung on 7.4.110.0 with memory allocation issues at load. |
CSCul65002 | WLC frequently crashes silently @ewaFormSubmit_exp_list with 7.4.110.0 |
CSCul68057 | CF driver change for 5508/WiSM2/2504 |
CSCuh71233 | Flex Stress Test: SYS-2-INTSCHED - all interrupts disabled |
CSCul50441 | AP: Crash: Check HEAPS; %SYS-6-BLKINFO: Corrupted redzone blk 12CE8C4 |
CSCul81023 | Controller crash with spamReceiveTask in 7.4.111.13 on HREAP setup |
CSCui11302 | write the image directly into flash |
CSCui67039 | Unable to downgrade WLC from 7.6.1.52 to 7.5 CCO build when in HA |
CSCuj88982 | multicast fails sometimes, WLC ignores IGMP, if AVC is enabled on wism2 |
CSCuj99846 | WLC HA: Incorrect Mesh AP count after HA failover |
CSCul20597 | Local EAP stops working after FTP config upload |
CSCul55930 | Saber 8500 Reaperwatcher crash |
CSCud10611 | Client exclusion notifications should be sent only to APs in the group |
CSCul25937 | Trap Scale improvements for client Association |
CSCul63384 | WLC system crash : Bonjour_Process_Task |
CSCuj88982 | multicast fails sometimes, WLC ignores IGMP, if AVC is enabled on wism2 |
CSCuj99846 | WLC HA: Incorrect Mesh AP count after HA failover |
CSCul20597 | Local EAP stops working after FTP config upload |
CSCul55930 | Saber 8500 Reaperwatcher crash |
CSCud10611 | Client exclusion notifications should be sent only to APs in the group |
CSCul25937 | Trap Scale improvements for client Association |
CSCuj99846 | WLC HA: Incorrect Mesh AP count after HA failover |
CSCuj64462 | AP radio flapping w/ CleanAir down, could not connect to spectrum FW |
CSCue20209 | cleanair unable to report interference. |
CSCue88466 | SC2 radio firmware download fails CRC check cmd for certain image sizes |
CSCui84582 | Bcast queue is full when IGMP is disabled -"RX Multicast Queue Full" |
CSCul30051 | Clients failing auth (psk/dot1x) due to uncreated dot1x interface for AP |
CSCud69687 | Talwar:AP count is not reflected correct in "show ap summary" |
CSCul22530 | Reaper Crash on Bonjour_Msg_Task |
CSCui36121 | AP crash in dot11_driver_timer_expiry() after AES-CCMP TSC replays |
CSCui82573 | Double AID allocation in OKC Fast Roaming in FlexConnect |
CSCud09069 | unable to add ip mask with 0.0.0.0 |
CSCue49527 | WLC should delete the session ID from PMK cache when client is removed |
CSCui50515 | dhcp proxy selecting wrong ip after using cached AAA override values |
CSCul16913 | massive AP radio's tx power changed when the system is overheated |
CSCul26859 | Not able to disable radius auth and acct for wlan thru GUI |
CSCul27717 | APs disassociate in large scale setup when debug commands are executed |
CSCui84582 | Bcast queue is full when IGMP is disabled -"RX Multicast Queue Full" |
CSCui66891 | Marvell-based radio goes down due to stuck multicast packets in driver |
CSCuj36260 | cannot disable mDNS snooping on WLAN with local switching after upgrade |
CSCuj87123 | Controller getting crashed while install license |
CSCuf16416 | .11h Client gets deauthenticated in non-dfs channel after dfs simulation |
CSCue59791 | Poor VPN Performance on 3600 APs |
CSCuj12898 | WiSM2 crashing on Bonjour_Msg_Task |
CSCuh25556 | Fix Aggr Sched AVL tree corruption crashes w/ design change to doubly-LL |
CSCui26351 | default route to BVI1 may stay on routing table |
CSCui43621 | 1552E flexconnect gig fiber port does not pass dhcp to wireless client |
CSCue25685 | Wi-Fi direct doesn't authenticate with 8500 |
CSCui25170 | APs can't join new WLC; mgmt int unreachable (BUFFER_POOL_LOW_DETECTED) |
CSCui55610 | Wrong status code returned for invalid FT IE MIC |
CSCui58670 | WLC sends M5 key with protected flag = 0 for a 802.11r SSID after a roam |
CSCuj21417 | AID leak causing Stale Client entries on WLC |
CSCuj25911 | wlc 7.4.110.0 RRM que full |
CSCuj28718 | WISM-2 in 7.4.110.0 code is crashing with "osapiReaper" task suspended. |
CSCud41334 | MAP Ethernet bridged client does not work |
CSCuj46010 | DTLS Conns getting dropped regularly causing APs to drop off from WLC |
CSCuj17884 | memory leak on HA AP SSO |
CSCuj18674 | captive portal/wispr support for apple ios7 |
CSCuc65606 | WLC crashes in spamreceive on 7.0.235.3 |
CSCud26706 | HA: Peer service port routes not shown after Switchover on 8510 |
CSCue34115 | 1552C Cable Modem AP's Gig Ethernet Link goes down. |
CSCug53945 | disabled radio is enabled after AP reload when AP group uses RF profile |
CSCug97769 | Device behind MAP unreachable after high AP uptime. Rebooting AP fixes |
CSCuh08009 | WPA2-PSK mac-filter assign interface wrong after client roaming back |
CSCui05324 | 1242 AP Radio Stops Transmitting - Transmit Queues Are Full |
CSCui20773 | Bcast queue is full -"RX Multicast Queue Full" |
CSCui25877 | Radio Reset: (ap1600) due to 'AMPDU attempt without BA setup from host' |
CSCui41685 | Add Show command support in CLI for Reap Payload |
CSCui59553 | Provide command to disable/customize dead GW detection for HA |
CSCui60915 | Mesh APs causing mac flapping and loop on the switch |
- Mark as Read
- Mark as New
- Bookmark
- Permalink
- Report Inappropriate Content
Great to see that we can get access to early release code for testing.
- Mark as Read
- Mark as New
- Bookmark
- Permalink
- Report Inappropriate Content
Hi George
Thanks for your comment!
Happy to see this helps, please let us know how the testing goes
regards
- Mark as Read
- Mark as New
- Bookmark
- Permalink
- Report Inappropriate Content
Javier,
I would really like to see the configuration documents released in EPUB format. Is there any chance of that happening in the future ?
- Mark as Read
- Mark as New
- Bookmark
- Permalink
- Report Inappropriate Content
Hi George
Doc team confirms that config documents and command reference are already in epub format:
Config guide: http://www.cisco.com/en/US/docs/wireless/controller/7.5/config_guide/b_cg75.epub
Command reference: http://www.cisco.com/en/US/docs/wireless/controller/7.5/command/reference/cr75.epub
Other tech docs will be published on epub format after December platform upgrade
regards
- Mark as Read
- Mark as New
- Bookmark
- Permalink
- Report Inappropriate Content
Hi Javier,
Will this release of code support the 3602I-Z AP? I am in a tricky situation where I cannot power on the 5GHz radio due to 7.4.110 code not supporting this AP. 7.5 does, however I have to downgrade to PRIME 1.4x which is not favourable.
Any information would be greatly appreciated.
- Mark as Read
- Mark as New
- Bookmark
- Permalink
- Report Inappropriate Content
hi
no sorry, for the moment, Z domain was added only on 7.5 and higher. if this is a mayor blocking point, please reach out to your account team, with the business impact/reasons so they can contact us an re-evaluate this if needed.
regards
- Mark as Read
- Mark as New
- Bookmark
- Permalink
- Report Inappropriate Content
Javier,
Will this code support the 1530 series APs
Regards
- Mark as Read
- Mark as New
- Bookmark
- Permalink
- Report Inappropriate Content
Hi Barry
No, 1530 support is introduced on 7.6, we normally don't add features/new HW to manteniance releases.
regards