Configure High Availability SSO on Catalyst 9800 | Quick Start Guide

[Cisco Document Team]

The Cisco Document Team has posted an article.

This document describes how to configure High Availability stateful switchover (SSO), on a Catalyst 9800 Wireless LAN Controller (WLC).

Know of something that needs documenting? Share a new document request to doc-ic-feedback@cisco.com

Your input helps! If you find an issue specific to a document, please let us know. Remember to provide as much detail as possible when submitting a request or feedback on an existing document including information regarding the section, area, or issue you had with the document and what could be improved.

You can provide feedback in a few ways:

• Using the Feedback button located at the right panel of the corresponding article.
• Submitting your feedback on an existing article or video, or new document request to doc-ic-feedback@cisco.com.
• If you are opening a TAC (Technical Assistance Center) case, you can notify your engineer of the gap or missing content and they can create a request on your behalf.

See How Cisco TAC is transforming documentation and simplifying self-service in this blog

[lostinspace]

Hello I am not seeing the document here is my question again. If I have SSO configured with the standby controller having .22 when the  WLC reboot wmy AP's joind the .23 contoller which is the third one in the SSO configuration correct, should I remove the seconday and tertiary controller form here, thanks