Greetings of the day:
Hello, I have a client who has three WAP4410N Firmware V 1.0.12 and Hardware Rev.12 all connected to an RVS4000 as a gateway, when using wireless clients to access wirelessly the management interface of all three only two open, the third one gets a page load error, when he closes one of the interfaces that did open and tries to open the one that didn't it works and the one that worked...does not for example .5 .6 .7 if .5 opens and .6 works .7 does not, if he shuts off .5 and tries to access .7 it works but .5 will not open. He is able to ping the device that won't open and able to go out to the internet, just no interface, anyone know if the wireless interface access is only two at a time? could this be a bug? he says the WAP4400N does allow more than two open at a time. Thanks in advance.
Regards,
Juan
