cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
983
Views
0
Helpful
1
Replies

WAP4410N - Repeater mode problem

Moustafa_Metwaly
Beginner
Beginner

Hi  , I got cisco  WAP4410N access point to use it as a repeater , I

set the same authentication, encryption and channel , then i went to

Repeater mode with site survey and choose my router's SSID and mac

address .... the signal is not repeated .. and the traffic is not

forwarded  to the router ...  and i get 2 SSIDs broadcasted one for the repeater  with limited access that cant reach the router , and the other is for my  router with alittle lower signal   but cant reach the repeater .. i  reset the configurations many times and tried to write my router's mac  address manualy at the repeater mode .. but still doesn't work .... i  tried 3 routers with the same problem .. I upgraded the firmware with the same problem .  any help?

1 Reply 1

Moustafa_Metwaly
Beginner
Beginner

I Fixed that issue by making my net work non secure  or by WEP  only  but WPA and WPA2 is not working ...... and now at repeater mode connection is drooped after few seconds and i have to restart the AP .. then it works for few seconds again then drop the connection .. i have the latest firmware what should i do ?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers