air ap2802i-e-k9

[Sbu]

Hi, I am struggling to configure my AP model air ap2802i-e-k9

after booting the I keeps on displaying the following:

And when I try to go on to config t mode It does not allow me.

Please help....!!!!

[Rich R]

@Sbu I'm 99% sure you did not follow the steps I advised.
1. Convert the AP to CAPWAP mode.
2. Install the CAPWAP image (not the ME image) 
https://software.cisco.com/download/home/286304510/type/286288051/release/15.3.3-JK7
Avoid 8.10.181.0 for now due to the bug mentioned in my signature - there'll be a new release shortly.
3. Convert (and upgrade) to the new ME image:
https://software.cisco.com/download/home/286304510/type/286289839/release/8.10.171.0

[Sbu]

I was using the wrong command, but I managed to upgrade to the new version, and also converting to ME, I am just stuck on getting my Guest WiFi working, I have configured the all the SSIDs with respective VLANs but no success.

[Rich R]

If you want help with that you'll need to be a bit more specific than "no success".
As in how is it configured and what is not working?
Have you done debugs on a client MAC?

[Sbu]

I am trying to configure Multiple WLANs two to be exact with WLANS in two different VLANs, I have configured both the internal and guest (WLAN)  SSIDs with the VLANs , But only the internal one has internet access.

[Rich R]

Do the clients get an IP address?

[Sbu]

No they do not 

[Rich R]

Is the vlan configured on the switches and allowed on the AP switch trunk ports?

[Sbu]

Sorry for the late reply, Yes the switch is configure and it allows trunk ports, but the only the Guest wifi has a problem. I am not able to connect to is at all