cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
775
Views
0
Helpful
3
Replies

Aironet AP 3600 Series Installation details

Sreejesh S
Level 1
Level 1

Hi team

 

 

  Here  I am trying to configure AIR-CAP3602I-N-K9  as standalone  for Demo purpose,but it could be not able to access via GUI, could you some body help me to get the first time installation for the same 

 

thanks

Sreejesh s

 

1 Accepted Solution

Accepted Solutions

Leo Laohoo
Hall of Fame
Hall of Fame

The part number you've quoted means the AP is running controller-based IOS.  This is why you won't be able to access GUI without a WLC.

View solution in original post

3 Replies 3

Leo Laohoo
Hall of Fame
Hall of Fame

The part number you've quoted means the AP is running controller-based IOS.  This is why you won't be able to access GUI without a WLC.

Sandeep Choudhary
VIP Alumni
VIP Alumni

As leo mentioned, you must convert it to Autonomous then only you can configure it.

Paste the info from AP: sh version

LAP to AAP conversion:

http://rscciew.wordpress.com/2014/05/07/access-point-conversion-lap-to-aap-and-vice-versa/

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp160918

Then to configure:

http://rscciew.wordpress.com/2014/05/24/single-ssid-configuration-on-autonomous-ap/

 

Regards

 

mohanak
Cisco Employee
Cisco Employee

for  Troubleshooting Lightweight Access Points follow the process: www.cisco.com/c/en/us/td/docs/wireless/access_point/1100/installation/guide/110h_c6.html

 

Review Cisco Networking for a $25 gift card