cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
161355
Views
21
Helpful
8
Replies

Aironet AP default password

Nusret Conk
Level 1
Level 1

What is the default password for AP1702i access point?

2 Accepted Solutions

Accepted Solutions

Alright, then just reset them to factory config and they will have the default password "Cisco"

Hope this helps,

-AL

View solution in original post

Sam Smiley
Level 3
Level 3

Nusret,

This should get you back to the defaults:

https://popravak.wordpress.com/2014/08/26/resetting-cisco-capwaplwap-access-point-to-factory-defaults/

Regards,
Sam

View solution in original post

8 Replies 8

aleopoldie
Level 3
Level 3

Did you try Cisco/Cisco as username/password ?

-AL

Al,

That didn't work. Any idea what it takes to reset it to the factory defaults?

It should be Cisco.

Are you sure it is a factory AP ?

AL

our customer bought a few months ago a couple of these. Not sure if they configured previously or not but today they want to give them a try.

Not sure if I answered your question of "factory AP"...

Alright, then just reset them to factory config and they will have the default password "Cisco"

Hope this helps,

-AL

Sam Smiley
Level 3
Level 3

Nusret,

This should get you back to the defaults:

https://popravak.wordpress.com/2014/08/26/resetting-cisco-capwaplwap-access-point-to-factory-defaults/

Regards,
Sam

Nusret Conk
Level 1
Level 1

Thank you Sam and AL

Alex Pfeil
Level 7
Level 7

I had converted an LWAPP to an autonomous AP.  I was then able to telnet into the AP.  I thought the username and password would stay the same, but it resets to the default. I was glad to come across this info.  The telnet username and password was Cisco after the conversion. Thanks!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: