Wireless

hi  i am facing a problem with one Access point that the flash is empty without any image , the access point start in the rommon mode how i can download an image in the flash ?what is the steps for that  ?? the access point model is 1700  thanx

Hello, am I understanding correctly that to disable SSLv3 (and mitigate POODLE) on a Cisco 5508 WLC, the command to issue in SSH under the config prefix would be switchconfig fips-prerequisite enable  ? If I enter this command does the WLC and assoc...

Hi Experts, I just upgraded the 5508 FUS the latest version (AIR-CT5500-K9-1-9-0-0-FUS).  After the upgrade, I issued the command sh sysinfo and I noticed that the field recovery image is still 6.0.182.0 and the USB console is still 1.27.  I am atta...

Hello experts, Could you please tell me how can i achienve this: WLC: 2504 AP: 1700 series SSID: Internel & Guest and Other Total AP: 15 5 Out of 15 AP should only broadcast "Guest" SSID  and 3 should only brocast ""Other" and rest AP must brodcast a...

Hello Everyone, I'm running 2504 and 1700 series of APs across locations. If i would like to use DNS name resolution "Cisco-capwap-controller.domainname" method. the challange is - each location is having saperate 2504 and if i put dns record for "ci...

I have 2 5508's in two data centers.  One of them already has a 3rd party SSL cert and it is working.  Can I install the same cert on the second WLC or do I need to assign a different Virtual IP and a different domain name for web authentication on t...

Gentlemen, I have the following doubts, I will make the upgrade of two WLC and WCS. The WCS to version: 7.0.240.0 (ED) And WLC to version: 7.0.252.0 The release of nodes WCS says it supports to the WLC with version 7.0.240.0. And the release of nodes...

HelloI have a fairly dense Wireless network with an Accesspoint per room. The 3502 models are connected to WiSM with Software 7.0.240.0 and are managed with Prime Infrastructure 2.2 (the issue was also in older PI versions).PI reports on the 802.11b/...