Good afternoon,Recently it was required to rebuild the PKI certificate and trustpoints for our cisco WLC (9800-CL). This was due to our internal audit team having concerns that the intial common name was the same as the trustpoint, and not matching t...
Hi,I'm trying to survey the presence of a given entry in the c9800 wireless controller mdns cache. SNMP does not seem to forward this kind of information, neither does netconf. The last idea was to ssh the command, but bash scripts work when executed...
Hi everyone, What equipment can replace the 1800s sensor, for use through DNA Center? because this hardware went into EoS?? Best Regards
Hi Everyone I’m currently working on a project that involves setting up several Cisco C910AXI-S access points, and I’ve run into a few issues that I hope someone here can help me with. Setup Details:• The AP is connected to a Netgear PoE switch.• The...
Hey everyone,I had a question about the Cisco WLC 9800CL. We are migrating over from using a Verizon provided MIST system. The MIST system uses a guest portal that requires the user to type in their full name, their email address, their company name,...
Hello,I have a Cisco AP C9130AXI-E that failed during an upgrade, resulting in both part1 and part2 getting corrupted. It only boots to BTLRD mode.I found this guide that I am attempting to follow: https://www.cisco.com/c/en/us/support/docs/wireless/...
Hello, everyone.I am currently setting up a massive network composed of at least 16 access points, all of them being Cisco Aironet 2800 Access Points. I am trying to implement a management network(switch) where all the networking devices are connecte...
Dear all, We have C9105AXI-EWC-C in our stock. we are planing to purchase C9105AXI-C of 15 unit. Plan is we want to use C9105AXI-EWC-C as a controller and 15 unit of C9105AXI-C access points under this EWC Controller. Is this solution possible and ok...
Cisco 9120 Access Point port is down and up and then the device does not work. To make the device work, you need to unplug the cable from the port on the back of the device and plug it back in.(The switch does not have a poe problem. After manually u...
I have new WLC 9800 connected to WLC 5520 and the mobility group is created and working just fine.The existing fabric for WLC 5520 is already there. DHCP and switching.For some reason, when a client joins to an AP that is controlled by WLC 9800, WLC ...
I need help with Cisco 9800 Catalyst controller AP pre download via cli - how to let AP's know which image to pre-download?? we can choose dedicated AP's but how to instruct to choose a specific image to pre-download??
Hi I am trying to change the EWC management Mac Address (0000.5e00.0101) but the command mac-address H.H.H (Manually set interface MAC address) isn't working. There is not option to change VRRP as well. Thank you for the help
I have an AP that's showing operational status disabled on slot 2, and when I click on it, I get "Dual Radio Mode is disabled on Primary Radio. Please click here to enable it and configure this Subordinate Radio"When I click on the "here", I get this...
Hi Everyone,I have an issue with some C9124AXI APs. Some of them can associate well but a couple of them are stuck in provisioning procedure.Image download went well in both case, but after that it shows "Response build failed".Here is the log:%CAPWA...
Hello All,I am trying to configure monitor mode for the Slot0 only on Cisco AP 3802. But it seems there is no command to do this. I am using C9800-CL-K9_IOSXE, Version 17.12.3Appreciate some help and advice on this.Thank you !
