Wireless

Hi All, Is there a way I can see the RF neighbors from a AP joined with the WLC, can the show controllers dot11radio 0 will help in thisRegardsNikhiL

We are using WLC 5520 controller and now want to join AP CAT-9105. As per datasheet it should support.But can anyone confirm it will work or not or any specific configuration needed?

Hello,I have few Windows 10 devices connecting to WLAN that’s WPA3 only . I’m using AES CCMP 128. When I look at the WIFI settings on the laptop it’s showing WPA2-Enterprise. But this WLAN setups to accept WPA3-Enterprise. I am using windows GPO to p...

We have currently 2 Cisco 9800 on prem CL-Controllers running version 17.3.5. Site A WLC is primary for endpoints in Site A and Site B is secondary WLC for endpoints in Site A and Vice versa. In our current setup we are running on low VM resources (H...

Hi ,The Cisco Catalyst IW9167 AP was introduced in June 2023; however, I have not been able to find it listed on the regulatory domain list. I have been searching on the following link, but with no success:Link: https://www.cisco.com/c/dam/assets/pro...

Hello,I am working on organizing devices that can support WPA3-Enterprise and Devices that can only support WPA2-Enterprise. I don’t want to run a SSID in a mix mode for security but I’m afraid having too many SSID might impact performance. With the ...

Hello, I have bought two 150AX access points and I fear that the second one cannot be configured as a Mesh Extender.I found a document describing how this is done on the older 140AC models: https://www.cisco.com/c/en/us/support/docs/smb/wireless/CB-W...

I want to Factory Reset a Cisco AIR-CAP3702I-A-K9 access point but can't figure out the mode button sequence.    1.) I tried holding the mode button, then provide power to the access point, and continue to hold mode button until I see an amber light....