Not able to configure the Access Point in standalone.

[laukik.nahar1]

Hi,

Have upgrade the IOS to ap3g2-k9w7-tar.153-3.JD

Please find the attached file for configuration done on Standalone AP.

I'm able to connect to Access Point using pre-shared key , but my Access point is not able to ping default-gateway , access switch or even DHCP server.

Need help for verification of the configuration and please share what more changes are required.

Also need to configure 3 Standalone AP's in mobility. It would be very helpful anyone can provide references.

Thanks

Laukik.

[Kundan Prasad]

remove these commands and then try pinging it..

ipv6 address dhcp
ipv6 address autoconfig
ipv6 enable

[laukik.nahar1]

Hi Kundan,

Tried changing the above configuration , still not working.

Thanks,

L

[Sandeep Choudhary]

i would suggest to reset the AP and start the config again from scratch.

Regards

Dont forget to rate helpful posts