cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
254
Views
0
Helpful
2
Replies

Prime 3.10 reports that my 9120AXI units have 3 radios

David Ritter
Enthusiast
Enthusiast

Prime 3.10 report that my 9120AXI units have either 2 radios, a+b (xor)  Traditional or 3 radios a+b (Xor)+n  the 'n' defined as aux radio main

All my units are configured the same  with only one drawing 30w poe and 8 drawing 23.2.  Yes that 3 radio ap is reporting 30w but some of the 23.2 units are also reporting 3 radios.  One of them has flipped the xor radio to A. thus  operating a+a+n

Where is that AUX radio turned on or off?

2 Replies 2

Rich R
VIP Advisor VIP Advisor
VIP Advisor

You don't mention what WLC you're using or what version of software?
Is this maybe the Bluetooth Low Energy (BLE) radio?
Check out: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-2/config-guide/b_wl_17_2_cg/ble_beacons_in_ciscowave_2_access_points.html and
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-10/config-guide/b_cg810/location_services.html
Those might help if it is the BLE radio.

___________________________________________
TAC recommended codes for AireOS WLC's
Best Practices for AireOS WLC's
TAC recommended codes for 9800 WLC's
Best Practices for 9800 WLC's
Cisco Wireless compatibility matrix
Field Notice: FN-72424 Later Versions of WiFi 6 APs Fail to Join WLC - Software Upgrade Recommended
WARNING - see CSCwd37092 Throughput degraded after upgrading to code 8.10.181.0/17.3.6 - 2800/3800/4800 series
- The fix for CSCwd37092 is now released in 8.10.183.0 and
- For IOS-XE 17.3.6 select controller model, go to IOS XE Software AP Service Pack, select CSCwd40096 17.3.6 APSP2
Field Notice: FN-63942 Lightweight APs and WLCs Fail to Create CAPWAP Connections Due to Certificate
                      Expiration - Software Upgrade Recommended
Field Notice: FN-72524 - During Software Upgrade/Downgrade IOS APs Might Remain in Downloading State
                     After 4 Dec 2022 Due to Certificate Expiration - Fixed in 8.10.183.0 and 17.3.6 APSP5 (APSP_CSCwd83653)
                     Also fixed in 8.5.182.7 (8.5 mainline) and 8.5.182.105 (8.5 IRCM) if you can't upgrade to 8.10
                     Note that 8.10.181.0 and 8.10.182.0 have been deferred (withdrawn) and are effectively unsupported by Cisco
___________________________________________
Richard R

Hi Rich,

the airos is 8.10.181.3.  I just checked and my 9117's are all depicted with the normal 2 'lobe' symbol.  however, when the 9117's were on the 9800-40, Prime depicted them with 3 lobes.

I don't have location enabled as the ap's name says it all and everything is working fine

Thank you

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers