cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5102
Views
10
Helpful
4
Replies

Turn off LEDs on AP 1240, etc

henry.benjamin
Level 1
Level 1

Hi folks I need to turn off all the leds on the aps we have installed as they are students sleeping quarters and some students are complaing the leds are keeping thme awake does anyone know how to turn the leds off completlely either via a software command or hardware thanks

1 Accepted Solution

Accepted Solutions

Rob Huffman
Hall of Fame
Hall of Fame

Hi Henry,

Give this a try;

config ap led-state

To enable or disable the LED-State for an access point, use the config ap led-state command.

config ap led-state {enable | disable} {Cisco_AP | all}

Syntax Description

config

Display configurations.

ap

Advanced parameters.

led-state

Enable or disable the LED-State for an access point.

{enable | disable}

Enable or disable the access point's LED-State.

{Cisco_AP | all}

Name of a Cisco lightweight access point or all to specify all access points.

http://www.cisco.com/en/US/docs/wireless/controller/4.1/command/reference/clic1.html#wp2384867

Hope this helps!

Rob

View solution in original post

4 Replies 4

Rob Huffman
Hall of Fame
Hall of Fame

Hi Henry,

Give this a try;

config ap led-state

To enable or disable the LED-State for an access point, use the config ap led-state command.

config ap led-state {enable | disable} {Cisco_AP | all}

Syntax Description

config

Display configurations.

ap

Advanced parameters.

led-state

Enable or disable the LED-State for an access point.

{enable | disable}

Enable or disable the access point's LED-State.

{Cisco_AP | all}

Name of a Cisco lightweight access point or all to specify all access points.

http://www.cisco.com/en/US/docs/wireless/controller/4.1/command/reference/clic1.html#wp2384867

Hope this helps!

Rob

thanks mate it worked

Hi Henry,

Good stuff! You are most welcome my friend.

Cheers,

Rob

Hi henry.benjamin,

To turn off the LEDs on the AP 1240 or similar devices, you can try the following steps:

  1. Access the AP's ETC configuration interface by entering its IP address in a web browser.
  2. Look for a section related to LED settings or system configuration.
  3. Within that section, you should find options to control the LEDs, such as turning them off or adjusting their brightness.
  4. Save the changes once you've disabled the LEDs.

Please note that the specific steps may vary depending on the AP model and firmware version. It's recommended to consult the AP's user manual or contact the manufacturer's support for precise instructions.

I hope this helps!

Review Cisco Networking for a $25 gift card