10-23-2014 09:47 PM - edited 07-05-2021 01:47 AM
Hi,
i have configured my wlc for the web authentication, now work fine. But for the login page i must insert manual te virtual ip of the WLC (1.1.1.1).
There is a method that when you connect to the SSID the web page is displayed automatically?
Thanks
Solved! Go to Solution.
10-25-2014 02:32 PM
What code of WLC version are you using ? Also make sure opening web page is http & not https (normally most of sites, like google, automatically use https & those won't redirect)
Also check your DNS to make sure it properly resolve URL. Also try by adding a DNS entry for 1.1.1.1 IP as well.
Here are some reference WebAuth config example which may help you as well
http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/69340-web-auth-config.html
HTH
Rasika
*** Pls rate all useful responses ***
10-24-2014 02:51 AM
Webpage not displayed when you connected to it. (client state would be WEB_AUTH_REQD)
You have to open a web browser & then it should redirect to login page. If you have configured WebAuth then user has to enter the credentials. If you have configured Web passthrough then no username verification (you can include enter email ID as an option). Then only client will be in RUN state.
Refer this for different webauth configuration options
http://mrncciew.com/2013/03/21/wlc-web-authentication/
HTH
Rasika
*** Pls rate all useful responses ***
10-24-2014 11:00 PM
Hi Rasika,
i configure the WebAuth but when i open the browser I'm not redirect to the login page, but if i enter the virtual ip the web page as shown.
Thanks
10-25-2014 02:32 PM
What code of WLC version are you using ? Also make sure opening web page is http & not https (normally most of sites, like google, automatically use https & those won't redirect)
Also check your DNS to make sure it properly resolve URL. Also try by adding a DNS entry for 1.1.1.1 IP as well.
Here are some reference WebAuth config example which may help you as well
http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/69340-web-auth-config.html
HTH
Rasika
*** Pls rate all useful responses ***
10-28-2014 07:28 AM
10-28-2014 10:59 PM
https redirect works from WLC software 8.0.x onward. Here is the 8.0.100.0 release notes of that code specifying this
http://www.cisco.com/c/en/us/td/docs/wireless/controller/release/notes/crn80.html
HTH
Rasika
**** Pls rate all useful responses ****
10-28-2014 10:59 PM
Fine, then now I upgrade the wlc.
thanks again
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: