WLC 2504 PPPoe session

[Murad*]

hi every one

i have WLC 2504 and its work normally , i want to create a new WLAN with Separated vlan but i want to work with PPPOE  service , i want to put my broadband user and broadcast it with Separate SSID ? 

Can i do that and how ?

[Flavio Miranda]

Hi

 You need to select the AP mode.

Take a look on this guide:

https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-0/configuration-guide/b_cg80/b_cg80_chapter_0101101.html

-If I helped you somehow, please, rate it as useful.-

[Murad*]

hi

 i tried to do that but when i changed the AP mode to flex-connect the AP change to (Standalone) mode!

and can't register with the WLC !

there is note to change MTU from AP , i connected the AP with console cable and changed his interface MTU to 1564 and the same problem stayed ( the AP cannot registered with the WLC ) 

[Murad*]

and another things 

if i enable flex-connect service where i can put my Broadband username and password ?

and can i enable more than VLAN in the same AP

my situation here is :

i have many place need service test every time , every place with a different VLAN , my idea here 

i want to create WLAN with B.B , and put username and password of Test-user , and just changed the VLAN id when i want to test another place , is all this clear ? and its possible or not ?

Best regards .