Correct ... View more

when i do the media flow-through command in the dial peer or the global it is not taking the command. but also im not getting any errors. ... View more

Hello Yes you are correct i cant route to 4.55.22.66 from my cube. but also i cant ping to it from another location either.   Also i sent a flowroute a ticket about the invite's. also, I added another debug for the outbound issue that other person cant hear me but I can hear them.  ... View more

Hi Dennis The IP 172.87.10.120 is our WAN IP from our ISP. and then 192.168.170.1 is the internal IP of our CUCME ... View more

Hi Dennis   I have attached a txt file with the ccsip logs. First one is calls from outside(My Cell) to Inside using the SIP trunk. This phone ring about three times and hung up. It about the time the CUE answered for voicemails.    and the Second log is from inside to outside(To My Cell Again). Inside to outside was just dead air when answered.   Thanks   Andrew ... View more

yes. I have attached a copy of debug ccsip messages of a call coming and when i answer it. and my current running config. it looks like im getting SIP/2.0 482 Loop Detected error once the call is answered.  ... View more

One other thing. If downgrade to CUCME 11.0 the calls work fine. But Once I upgrade to CUCME 12.0 this problem happens. I would like to use 12.0 for the native support for the 8845 IP phones that we have. I have also checked with my sip provider and im CUCME is selecting the g711ulaw codec from them. ... View more

I have discovered a new issue with this. When I have an incoming call coming in from my sip trunk provider. The IP Phone will ring normally but once I try and answer it. It will drop the call right away on the IP Phone   ... View more

I found where the issue was. I was testing a freepbx box and it must have taken the sip session once i switch CUCME hardware. i have disabled that and now my CUCME is working correctly now. thanks for the help.  ... View more

I have attached the debug log. I have called another 3 times using 2 cell phones and all three times it failed to ring the phone.   The IP Phone says i have 3 missed calls but the phone never rang.  ... View more

The IP Phones are not ringing. So if I call from my cell to one of the sip numbers I get a message "The number is not service" but I may get this message 10 times and one will finally go through fine and ring the Phones and then will forward to CUE fine. If I call my POTS Line it working fine all the time.   I am not natting the WAN Side of The CUCME it has a public IP from my ISP. There is nat setup on ISR for the internal networks.    I have attached my current running config and I also called the sip number twice one want through fine and other did not. I have commented which ones they were.    Thanks ... View more

I think I have the issue with CUE fixed I had to downgrade my IOS version and now calls are going to cue correctly using the sip trunk. but now I also have a new issue that when I call one of my sip trunk numbers it will work normally once or twice. but most of the time it will do a half ring on a phone once and then will say "The number is not in service" or won't even ring the phone. it almost seems like it is not hanging up the call that did work.  This has been just a nightmare to get working correctly, Now I'm wishing I had never upgraded my CME/CUE hardware.   ... View more

Thanks for the info. I have tried adding transcoder but it still requesting g729 codec and is not transcoding. But I'm also not sure if the config for the transcoder is correct. I have attached the current config. I also have a ticket in with my provider to see if I can get them to change to g711 or give me some more information. I'm not a voice expert but know enough  to be dangerous.  ... View more

Here is updated debug ccsip message and running-config ... View more