날짜: 06-10-2024 09:49 AM
날짜: 06-14-2024 01:47 AM
안녕하세요?
스크린샷 올릴 수 있어요?
날짜: 06-16-2024 11:24 AM
When I run do sh run as above, only part of the output is displayed and the rest is not displayed.
Maybe it's supposed to work this way?
날짜: 06-16-2024 01:11 PM
Breakout과 함께 사용하는 터미널 에뮬레이터 앱에 흐름 제어가 비활성화되어 있는지 확인하십시오. 앱이 터미널 출력을 제한하기 위해 x-off를 전송하면 IOS는 전송을 중단하며 "more(자세히)" 프롬프트를 표시하지 않습니다.
날짜: 06-16-2024 01:55 PM
I'm doing this in Powershell and I don't see anything called flow control, should I use Putty?
날짜:
06-16-2024
05:42 PM
- 마지막 편집 날짜:
06-19-2024
10:58 AM
, 작성자:
CiscoKoreaModer
안녕하세요?
PowerShell에서 $FormatEnumerationLimit 값을 확인해 보세요. 제가 알기로 기본값은 4입니다.
PS C:\Users\powershelluser>$FormatEnumerationLimit
-1로 변경해 보세요.
PS C:\Users\powershelluser>$FormatEnumerationLimit =-1
날짜: 06-16-2024 07:41 PM
This method does not work.
날짜:
06-16-2024
08:03 PM
- 마지막 편집 날짜:
06-19-2024
10:58 AM
, 작성자:
CiscoKoreaModer
PowerShell을 실행하기 전에 Cisco에서 'term length 0'을 구성하면 어떻습니까?
날짜: 06-16-2024 08:08 PM
I tried, but it didn't scroll and I could only see the very end.
날짜:
06-16-2024
09:04 PM
- 마지막 편집 날짜:
06-19-2024
10:59 AM
, 작성자:
CiscoKoreaModer
안녕하세요?
PowerShell에서 'More'가 표시되면 '~' 키를 누르세('1'의 왼쪽에 있는 tilde). 이러면 ENTER와 같은 작동을 할 것입니다.
날짜:
06-17-2024
10:14 AM
- 마지막 편집 날짜:
06-19-2024
11:00 AM
, 작성자:
CiscoKoreaModer
저 같은 경우, 브레이크아웃을 하니 퍼티가 잘 작동됩니다.
새로운 아이디어를 발견하고 저장하세요. 전문가 답변, 단계별 가이드, 최근 주제 등 다양한 내용을 확인해 보세요.
처음이신가요? 아래 팁들을 확인해 보세요. 시스코 커뮤니티 사용하기 새 멤버 가이드