If SNMP is setup will the PIX send a trap or make a syslog entry if a VPN tunnel dies? Is there an SNMP value I can poll? What is the normal method to monitor the health of a VPN connection on a PIX?Thanks,Scott
TAC has informed me that I am experiencing a known bug that causes my database to keep expanding. I was told my only workaround is to re-install CiscoWorks VMS every 5-7 days. After install number 3 I tried to run Event Viewer in Security Monitor and...
I have a VPN3000 (ver 3.5) at the hub site with PIX 501's deployed remotely. Remote sites can bring up a tunnel without any problem. Once the tunnel is up traffic can be initiated by either side and there's full connectivity.When the tunnel drops onl...
I have a VPN3000 (ver 3.5) at the hub site with PIX 501's deployed remotely. Remote sites can ping the hub site but not another remote site. I have enabled RRI (but not RIP or OSPF) on the VPN3000 and see the routes in the routing table. Pings timeou...
Thanks but the question isn't HOW to configure SNMP but really when SNMP is configured, will the PIX give any indication that a VPN connection is lost. It looks like the consensus is, that other than pinging something on the other side, there is no w...
Started to post a question, then found that you beat me to it. Only difference is that on my 535's it is only the ouside and stateful interfaces. Also I am running 6.22. I have changed cables and ports on the switch. Anyone have any ideas as to the ...
Thanks Yatin,We have IDSMC/SecMon 1.1.1 with all the patches and still no go. I had my Cisco rep order VMS 2.2 and hopfully this will fix things as VMS 2.1 is a real disaster. So far we have hit 3 bugs with no workarounds. TAC had no idea about the J...
I see, its similar to what has to be done if your hub is a PIX. One question though, if I remember correctly each line of the crypto ACL is used to create an security association. Right now each 501 has two tunnels, one for the remote LAN on the insi...