Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My daughter has a HP IPAQ and my PIX 501 generates the following message:%PIX-1-106021: Deny udp reverse path check from 169.254.2.2 to 255.255.255.255 on interface insideMy daughter has an HP IPAQ and I think that this is coming from her IPAQ trying...
I am using a PIX 501 50 user device and the suddenly the internet started going up and down. Looking at my Syslog entries I found a lot of the following entries:2006-05-02 18:26:41 Local4.Error 192.168.1.1 %PIX-3-305006: portmap translation creation...
I am a home user and cannot figure out how the auto-update feature works. If I check the enable feature other fields become available to be filled in. Is this information update directly from Cisco and if so what is put in the fields to make the au...
I have a PIX 501, 50 user license, for my home LAN which consists of approximately 20 computers.I have been reading different books on the PIX and most of them show a router and then the PIX and then the internal network.Would there be any advantage ...
I have a PIX 501 and I was thinking of adding VOIP. Are there any thoughts on what would be a better match with the PIX 501: the Cisco ATA-186 or the Linksys Telephone Adapter?Also I noticed that there are several ports that must be forwarded in or...
I have a PIX 501 with a 50 user license. I am running FAH and have 4 home computers that are for the family use and are always in use.In addition to these I have 12 computers dedicated to FAH at home 3 which have dual cores running 24/7/365. I have...
Yes, you are correct. I currently have the following setup:Cable Modem -> PIX 501 -> Switch -> Internal LANI think that where I was going was if I placed a router between the CM and the PIX 501 would there be anything gained as far as additional pro...
