Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi...I?ve configured my Cisco ASA 5510 Firewall with four subnets. Each one for different purposes, described as following:100.130.101.0/24 network. Named UnTrust network is use it for all user inside the office.100.131.101.0/24 network. Named Trust ...
I did it but it still do not work. From console I get the following output:FwCorporativo(config)# no static (untrust,trust) 10.30.1.0 10.30.1.0 netmask 255.255.255.0FwCorporativo(config)# FwCorporativo# pingInterface: trustTarget IP address: 10.30.1....
Thank for your response. I try it But it did not work. All traffic is still dropping it. First I will send it my entire configuration file. This file has the real addresses use it in my network. Please understand me, Innitialy I changed my real addre...
Thank for your response. I try it But it did not work. All traffic is still dropping it. First I will send it my entire configuration file. This file has the real addresses use it in my network. Please understand me, Innitialy I changed my real addre...
I tried configuring tha NAT rule described in your comment. But, My ASA still continue blocking all traffic. The NAT rules used area:1) A single NAT rule from Trust to UnTruststatic (Trust,UnTrust) 100.130.101.0 100.131.101.0 netmask 255.255.255.02) ...
