Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Let me start by saying it has been some time since I have configured any cisco device. I have an ASA 5505 that I cannot ping through. as of right now for testing I have the network setup as follows. I have a server on the inside interface at IP 192.1...
Well I was playing around with the settings here and I have found that if I set the outside security level higher than the inside the UDP traffic flows no problem. The server and client can talk both ways. Thank you for all of your help rick. I will ...
Is there any way to set this up as passing any and all traffic through? When these devices go live on the network the ASA is pretty much going to be just an SLA monitor point.
Hey Rick,
Sorry I am so green to this. Here is the show ARP command
routeswitch(config-pmap)# sho arp inside 192.168.3.16 6469.bc04.dfbf 41 inside 192.168.3.10 a0b3.cc23.da1e 261 outside 10.23.15.9 6469.bc04.e8cb 10
I am unsure what commands to run t...
