Hi Everyone, I am trying to setup intervlan routing with a Cisco ASA 5510 and two 2960-S switches. The 5510 currently is using ASA Version 7.0(2) and has a base license. I tried to create a sub interface today based on some info I found regarding...
Hi Everyone, I have a good one for you guys. I'm new to ASA's and PIX units. I've setup a few VPN's now but know next to nothing about logging on these units. I read the config guide for the PIX, but cannot figure out how to ge...
Hi Everyone, I'm getting an error message on my 506E that is saying not enough flash space to install the new version 8 software. I did a clear flashfs command and then tried again but get the same error. Do you guys / gals kno...
Hi Everyone, Here is the show ver... LYSMcM-ASA# sh verCisco Adaptive Security Appliance Software Version 7.0(2) Compiled on Fri 15-Jul-05 22:55 by buildersSystem image file is "disk0:/asa702-k8.bin"Config file at boot was "startup-config"LYSMc...
Hi Everyone, I pasted below an output from putty... I tried conf t, then int Ethernet0/2.3, then it gave the error message. I can go to interface Ethernet0/2 just fine, it just doesn't like the sub interface commands... LYSMcM-ASA# conf tLYSMcM...