How to Form a Catalyst 3850 Data-Stack and Power-Stack
Introduction
This document describes the process to properly form a stack-wise and power stack with Cisco Catalyst 3850 switches. It also shows the use of some commands that will help to trou...
Hello JP,
The answer to your question is yes. A 350W power supply can be used in each switch along with stack power. Also, the 350W power supply will be able to support both switches if one of the PS fails, meaning they both will remain up with only...
Hello Abhishek,
Up to four switches can be part of a power stack in a ring topology, and up to nine switches can share power in a star topology by using an XPS.
Please find below a link that explains this process in more detail:
https://www.cisco....
Hi Ronald,
This is a curious case, as the objective of having a switch stack is to have some kind of redundancy in case one of the switches fails.
If only one cable is disconnected or only one port is shouted down the stack should remain up and runn...
Hi Geeksturt1,
I was away for holidays and did not have access to email.
Regarding to your question, could you please let me know the following:
I guess you have created power-stack names Powerstack-1,11,12 and 13 correct? Also, have you tried to ad...