Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Thanks Gareth. In that case, another method might be to group the inside hosts that are sending the telemetry and suppress the alarm for that host group as a source.
Hi Gareth, the alarms and security events documentation describes the source of this alarm as the host that is receiving the files. The target is defined as the hosts that are sending the files. Based on that, could you please test your policy config...
Hi, yes this is possible. You've already added the new interface in vCenter: To add a second network interface to an SNA Flow Sensor v7.5.3, you need to configure the additional network interface through Central Management as the Flow Sensor network ...
Hi, assuming there are no issues with basic connectivity to the manager or interface configuration on the new FS, I would recommend a TAC case in this instance.
Hi, I realise that you mentioned this in your message but when you reach this screen during the FTS process you are certain that you are using the correct manager details (IP and password) and not the password that was set earlier in the FTS process ...
