Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i need set up a two wires (ports) port channels on a single 32 ports card. Is there any limitations for? How match ports could be used for hosts after?
How will FSPF counts path weight in port chanal case? For example - there is two fisical lincks with different speeds - 2 and 1 gig. What fspf count i'll have?
MDS series is supported by RME 3.5. MDS dev. are in RME comp. list. Check - http://www.cisco.com/en/US/partner/products/sw/cscowork/ps2073/products_device_support_table09186a008017aee3.html
Yes, it works. But i guess port zone membership could be found into fcid. If i remember fcid addresse includes 3 parts:domain, area, port. Area part is used only on AL and I suppose area bits in switching fabric could be used for port zone membership...
