Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
A Field Guide covering the installation and initial configuration of Cisco Compute Hyperconverged with Nutanix systems using Intersight Managed Mode for Cisco UCS Unified Edge servers. Intersight Managed Mode (IMM) is the term for Cisco Unified Edge ...
A Field Guide covering the installation, configuration and integration of the Cisco UCS X580p PCIe Node into a Nutanix cluster running on Cisco UCS X-series Modular Servers. The Cisco UCS X580p PCIe Node, plus the associated X9516 X-Fabric modules an...
A Field Guide covering the installation, initial configuration, and expansion of Cisco FlashStack with Nutanix clusters using Intersight Managed Mode (IMM) on UCS X-series, C-series, and B-series servers connected to Pure Storage FlashArray external...
To ensure the correct installation process is being followed for Cisco Compute Hyperconverged with Nutanix, please refer to the following flowchart to choose the correct documentation for the system being installed:
This document covers the IMM dep...
To ensure the correct installation process is being followed for Cisco Compute Hyperconverged with Nutanix, please refer to the following flowchart to choose the correct documentation for the system being installed:
This document covers the ISM d...
Ziad, the servers will have no configuration out of the box as is normal for all Cisco UCS servers. You must use Foundation Central (which is part of Prism Central) to set the configuration of the servers vis Cisco Intersight. That same cluster confi...
Yes, the factory imaging allows you to skip imaging during the cluster creation job, but you still need to use Foundation Central (via Prism Central) to create the cluster after you receive your servers.
Hello jomebrew,
All traffic in an IMM deployment will be tagged with a VLAN ID leaving the hypervisor and controller VMs, so using VLAN 1 as a native VLAN can cause problems. In general we don't recommend using VLAN ID 1 and to avoid setting a native...
Prism Central is not used for the LCM jobs, you should use LCM via Prism Element. In there, it will ask you to connect to Intersight using your API key when you run an inventory job.
