Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Iìd like to understand if applying reverse nat on ASA firewall is a good practice or is deprecated due ASA's security logic of inside and outside inteface concept.
Thank you in advance for any kind reply.
Regards
angelo
Hi,I have two ACE20 module installed in two Catalyst 6505 chassis, they are configured in fail-over mode with 3 virtual contexts, one admin conterxt and two user contexts. One ACE is Active for Admin context and host-standby for the other two context...
Hi,I have a 5550 working in routed mode with 8.0(4) version. My configuration have one physical interface in tunnel mode with 4 subinterface, 3 of them are inside and the forth one is dmz interface. Another phisical interface is configured as Outside...
Hello,I would like to know how many Nexus 2000 does Nexus 5548 support? I am looking for this information but i didn't found it.Thank you in advance for your reply.Regards angelo
Hi, I've built a web application load balanced by an ACE module on a Catalyst 6509. I have some doubt to choose the ACE one-arm or two-arm routerd mode. Right now I've built the following architecture:FWSM--------------------------------------- ...
Hi pablo, i am referring to configuration of ASA pre-8.3 with nat-control enabled and with reverse nat i mean the configuration of natting from outside to inside which is in my mind in contraddiction respect normal ASA behaviour. is that also depreat...
Hi Kanwal, thanks for your reply.Does it mean that I should have to see the same connection first arriving on Active ACE and then replicated on the Hot-standby one?So cause I have to measure the resource usage actually in use by contexts for future n...
Hi,thanks for infomation. Does it also mean that a couple of 5548 in vpc domain configuration can still support up to 12 in am ACTIVE-ACTIVE mode?Regardsangelo
