Buenas!
Tengo una pequeña duda referente a los PVDM2 y los canales
Con un PVDM2-16:
C2811#sh diag | Begin PVDM
PVDM Slot 0:
16-channel (G.711) Voice/Fax PVDMII DSP SIMM PVDM daughter card
Product (FRU) Number : PVDM2-16
Cuantos canales analogicos puedo poner en el router? Hablo de tarjetas FXO y FXS
Ahora tiene una VIC2-2FXO y necesito saber si podria poner una VIC2-2FXS con un modulo PVDM2-16
En este otro hilo: https://supportforums.cisco.com/document/123126/cisco-pvdm2-and-pvdm3-dsp-creditmips-allocation
vi esto:
PVDM2-16 - Signaling
- 16 calls for G711 (flex mode only)
- 8 calls for the other medium complexity codecs and g711 in medium complexity mode
- 6 calls per DSP for high complexity codecs
- 240 MIPS in flex mode
- G711 uses 15 MIPS per call (240 MIPS / 15 MIPS per call = 16 calls per DSP)
- The codecs under the High Complexity category use 40 MIPS per call.
- The codecs under the medium complexity category use 30 MIPS per call.
- The D channel doesn't count for resources
- Each FXO or FXS port takes 1 channel
- Each Pri slots also count for 1 channel
Pero no me queda claro.
No soy capaz de ver los canales sin asignar con comandos:
C2811#show voice dsp group all
DSP groups on slot 0:
dsp 1:
State: UP, firmware: 24.3.6
Max signal/voice channel: 16/16
Max credits: 240
num_of_sig_chnls_allocated: 2
Transcoding channels allocated: 0
Group: FLEX_GROUP_VOICE, complexity: FLEX
Shared credits: 240, reserved credits: 0
Signaling channels allocated: 2 <--------------------------------- Canales ASIGNADOS
Voice channels allocated: 0
Credits used: 0
C2811#show voice dsp detailed
*DSP SIGNALING CHANNELS*
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABRT PACK COUNT
===== === == ========= ========== ===== ======= === == ========= == ==== ============
C5510 001 01 {flex} 24.3.6 alloc idle 0 0 0/2/0 02 0 36/0
C5510 001 02 {flex} 24.3.6 alloc idle 0 0 0/2/1 06 0 36/0
------------------------END OF FLEX VOICE CARD 0 ----------------------------
Un saludo
