Buenas tardes comunidad,
Tengo un problema con un equipo SPIAD2911CME16F/K9, con ios 2900-universalk9-mz.SPA.156-3.M5.bin, pero al configurar lo recursos de hardware para poder realizar más conferecias, no levanta el sccp:
h sccp
SCCP Admin State: UP
Gateway Local Interface: GigabitEthernet0/1.2
IPv4 Address: 192.168.42.1
Port Number: 2000
IP Precedence: 5
User Masked Codec list: None
Call Manager: 192.168.42.1, Port Number: 2000
Priority: N/A, Version: 7.0, Identifier: 1
Trustpoint: N/A
Transcoding Oper State: ACTIVE_IN_PROGRESS - Cause Code: TCP_CONN_ERROR
Active Call Manager: 192.168.42.1, Port Number: 2000
TCP Link Status: NOT_CONNECTED, Profile Identifier: 2
Reported Max Streams: 20, Reported Max OOS Streams: 0
Supported Codec: g729r8, Maximum Packetization Period: 60
Supported Codec: g711ulaw, Maximum Packetization Period: 30
Supported Codec: g711alaw, Maximum Packetization Period: 30
Supported Codec: g729ar8, Maximum Packetization Period: 60
Supported Codec: g729abr8, Maximum Packetization Period: 60
Supported Codec: rfc2833 dtmf, Maximum Packetization Period: 30
Supported Codec: rfc2833 pass-thru, Maximum Packetization Period: 30
Supported Codec: inband-dtmf to rfc2833 conversion, Maximum Packetization Period: 30
Conferencing Oper State: ACTIVE_IN_PROGRESS - Cause Code: NOT_REGIS_WITH_CCM
Active Call Manager: NONE
TCP Link Status: NOT_CONNECTED, Profile Identifier: 1
Reported Max Streams: 160, Reported Max OOS Streams: 0
Supported Codec: g711ulaw, Maximum Packetization Period: 30
Supported Codec: g711alaw, Maximum Packetization Period: 30
Supported Codec: g729ar8, Maximum Packetization Period: 60
Supported Codec: g729abr8, Maximum Packetization Period: 60
Supported Codec: g729r8, Maximum Packetization Period: 60
Supported Codec: g729br8, Maximum Packetization Period: 60
Supported Codec: rfc2833 dtmf, Maximum Packetization Period: 30
Supported Codec: rfc2833 pass-thru, Maximum Packetization Period: 30
Supported Codec: inband-dtmf to rfc2833 conversion, Maximum Packetization Period: 30
Al realizar pruebas del puerto tcp 2000 para ver si está abierto, se realizó la prueba de TELNET a través del puerto 2000 pero no lo abre:
telnet 192.168.42.1 2000
Trying 192.168.42.1, 2000 ...
% Connection refused by remote host
Y no tengo ningún ACL bloqueando el puerto, será cuestión de IOS o será cuestión del mismo equipo.
Saludos!
