思科控制器sp口在console配置可以访问web

[qinggechen81373]

思科控制器sp口在console配置可以访问web吗，用什么命令可以恢复默认设置

[Rps-Cheers · Accepted solution]

思科WLC的Service Port就类似于交换机的带外管理口，可以配置用来CLI和WEBUI管理WLC。
主要就是IP地址的配置，如果恢复默认的，就不配置IP地址就好了。

[qinggechen81373]

(Cisco Controller) >show interface detailed service-port
Interface Name................................... service-port
MAC Address...................................... 30:e4:db:1b:32:81
IP Address....................................... 0.0.0.0
DHCP Option 82................................... Disabled
DHCP Protocol.................................... Disabled
AP Manager....................................... No
Guest Interface.................................. No
这个端口怎么配置IP呢，用什么命令

[Rps-Cheers]

qinggechen81373 发表于 2021-4-7 11:48
(Cisco Controller) >show interface detailed service-port
Interface Name......................... ...

Step 1
To view the current service-port interface settings, enter this command:
show interface detailed service-port
Note
The service-port interface uses the controller’s factory-set service-port MAC address.
Step 2
Enter these commands to define the service-port interface:
To configure the DHCP server, enter this command:
config interface dhcp service-port enable
To disable the DHCP server, enter this command:
config interface dhcp service-port disable
To configure the IPv4 address, enter this command:
config interface address service-port ip-addr ip-netmask
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration-guide/b_cg75/b_cg75_chapter_011110.html#ID552