Rocky 发表于 2019-1-16 23:04
这一篇文档也可以参考一下
Bootloop in 1852i after firmware upgrade
https://community.cisco.com/t5/w ...
按照说明把ap1g4 renamed to part.bin
(RNAQ-C7) # bootipq tftp
Specified BOOT: part1
Booting from tftp
Full duplex link
Port:2 speed 1000Mbps
Using eth0 device
TFTP from server 192.168.1.10; our IP address is 192.168.1.1
Filename 'part.bin'.
Load address: 0x45000000
Loading: #################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#####################################################
done
Bytes transferred = 42762240 (28c8000 hex)
Image start 0x45000000 size 0x00000400
Key start 0x45000400 size 0x00000230
Sinature start 0x45000630 size 0x00000180
Signature returns -2
Image signing verification failure, not allowed to run...
exit not allowed from main input shell.
(RNAQ-C7) #