Now I have a cisco 9130axi, I made this ap into EWC mode, and successfully released the ssid in the GUI interface. However, when I restarted the AP, the ssid that was normally released was no longer released, and I waited for about 20 minutes for the restart, but the situation did not improve. I am sure I have saved the relevant configuration before restarting, either CLI or GUI. Specially came to the community to consult the engineers.
thanks~
You can check whether the internal AP is successfully registered through the "show ap summ" command. If the internal AP is not registered, the SSID cannot be released.
But at present, my problem is that I cannot log in to the GUI through the network cable after the AP restarts, and the AP does not release the saved SSID before, so every time I restart the AP, I can do nothing except reset the AP