AP 2602E 出现一种情况报错信息如下：
镜像版本较低时：Warning: the compile-time code checksum does not appear to be present.
Radio0 present 8764 8000 0 A8000000 A8010000 0
Rate table has 244 entries (64 SGI/104 BF variants)
Radio1 present 8764 8000 0 88000000 88010000 4
*Mar 1 00:00:09.911: %IFMGR-7-NO_IFINDEX_FILE: Unable to open nvram:/ifIndex-table No such file or directory
*Mar 1 00:00:09.995: %SOAP_FIPS-2-SELF_TEST_IOS_SUCCESS: IOS crypto FIPS self test passed
*Mar 1 00:00:17.051: %SOAP_FIPS-2-SELF_TEST_RAD_SUCCESS: RADIO crypto FIPS self test passed on interface Dot11Radio 0
*Mar 1 00:00:47.775: %DOT11-6-GEN_ERROR: Error on Dot11Radio1 - Radio Firmware Download Error: Waited for MRVL_PCI_INTCODE_REG to match the expected
'firmware ready' signature, but gave up while it was 0x%x
*Mar 1 00:00:59.795: %DOT11-2-RESET_RADIO: Restarting Radio interface Dot11Radio1 due to nop failed
*Mar 1 00:00:59.795: %DOT11-2-NO_PWR_TBL: Interface Dot11Radio1, no radio Power Table file (flash:/ap3g2-k9w7-mx.152-2.JA1/A5.bin) was found
*Mar 1 00:00:59.815: Unsupported radio found of type 0
但还可以正常运行。
ap#show ip int br
Interface IP-Address OK? Method Status Protocol
BVI1 10.0.0.254 YES manual up up
Dot11Radio0 unassigned YES unset up up
Dot11Radio1 unassigned YES unset reset down
//状态一直是reset
GigabitEthernet0 10.0.0.253 YES manual up down
ap#
镜像版本较高时：
Radio0 present 8764 8000 0 A8000000 A8010000 0
Rate table has 650 entries (20 legacy/224 11n/406 11ac)
POWER TABLE FILENAME = ram:/B2.bin
Radio1 present 8764 8000 0 88000000 88010000 4
timeout waitin for fw ready
nop failed
*Mar 1 00:00:14.543: %SOAP_FIPS-2-SELF_TEST_IOS_SUCCESS: IOS crypto FIPS self test passed (15)
*Mar 1 00:00:20.159: %SOAP_FIPS-2-SELF_TEST_RAD_SUCCESS: RADIO crypto FIPS self test passed on interface Dot11Radio 0 (4)
*Mar 1 00:01:02.791: %DOT11-5-EXPECTED_RADIO_RESET: Restarting Radio interface Dot11Radio0 due to IOS reload
*Mar 1 00:01:03.591: %SYS-5-RELOAD: Reload requested by Init. Reload Reason:
Radio FW image download failed ....IOS Bootloader - Starting system.
不断重启
是不是低版本的时候，对5g天线的要求不严格。高版本对没有5G天线的情况就实施重启，逻辑就是通过重启来恢复？？
