cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
571
Views
0
Helpful
0
Replies

Outdoor access point connected with two patch antennas

Hein555
Level 1
Level 1

Good day,

 

I would like to find out if it is possible to connect two patch antennas to the Cisco 1562E?

Like the AIR-ANT2513P4M-N= or something similar?


The idea is to use this in a warehouse setup where the access point will be on the end of the rack and then I want an antenna pointing down each row on opposite sides of the access point. So one access point to cover two rows with directional antennas.

I know the 1562 has four connectors for antennas, I am guessing two for 2.4Ghz and two for 5Ghz?
So I need to broadcast the 2.4Ghz down both the rows as it will predominantly be used for barcode scanners.  So perhaps a directional dual band antenna with two cables, one to the 2.4Ghz and one to the 5Ghz  that will cover each row?

 

Kind Regards

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: