Bonjour,
Est-ce que vous auriez une idée pour mettre à jour le firmware ?
Procédure de mise à jour firmware suivi : https://www.cisco.com/c/en/us/support/docs/smb/wireless/cisco-small-business-100-series-wireless-access-points/smb5706-upgrade-the-firmware-on-the-wap125.html
WAP125-E-K9-EU V01 Firmware 1.0.0.7 active / non active MD5 : 9ba281667438e581d0778416b631175b
PC win 10 en RJ45 + WAP125 en RJ45
Upgade /http - chrome / edge > échec
upgrade /TFTP - Tftpd64 by Ph. Jounin > échec
2 Firmware testés : https://software.cisco.com/download/home/286314846/type/282463166/release/1.0.2.0
WAP125_1.0.2.0.tar
WAP125_1.0.1.7.tar
Non testé WAP125_1.0.0.7.tar MD5 Checksum 72015ae52dfae50db009b203e74387ad
Upgrade Message 1
The new software has been successfully uploaded to the AP.
The AP will now save the new software,load it, reboot and come up with the last saved configuration.
The AP will be unavailable while the upgrade is taking place.Do not power down the access point while the upgrade is in process.
This process will take approximately 6 Minutes.
Upon completion, the AP will re-boot and the Logon page will be displayed so that you can re-login.
If the IP address of the AP has changed,you will need to access the Logon page manually at its new IP address.
Please wait, upgrade in progress:
Upgrade Message 2
The AP has not responded in the expected amount of time. The AP may now be using a different IP address, need more time to initialize, or the upgrade may have failed. You can continue to wait if you believe the AP needs more time to fully initialize.
La borne clignote en boucle > 15 fois vert + 1 fois vert/bleu/vert
Bouton reset +15 secondes, borne reprend firmware 1.0.0.7 active / non active MD5 : 9ba281667438e581d0778416b631175b
Merci d'avance pour vos conseils
