le 14-03-2024 03:10 AM
Hello I have some trouble with figuring out a solution to make it work for my networkI have a cat 6500 I have interface vlan 60 with network/24 and I need to bind the same network with an other routed physical interface . In short I need to route the same network on the 6500 Switch via two different sources ( interface vlan )and (routed interface , because this one is bundled with an other switch of datacentre via etherchanel and work through encapsulation dot1q and IP address) But I could not give 2 adresses for the previews interfaces from the same network there will be an overlap .Please help me Thank you
le 14-03-2024 04:04 AM
Router or SW not accepting two interfaces with same subnet.
MHM
le 14-03-2024 04:26 AM
Even with using bridge group?
le 14-03-2024 04:29 AM
the Bridge group will bridge two L2 interface and the only IP you need is for BVI which represent subnet for both interface.
MHM
le 14-03-2024 08:57 AM
Have you considered using secondary IP addresses on the Fsginspections interfaces to avoid overlap? Alternatively, subnetting might provide a solution to route the same network via different interfaces.
Découvrez et enregistrez vos notes préférées. Revenez pour trouver les réponses d'experts, des guides étape par étape, des sujets récents et bien plus encore.
Êtes-vous nouveau ici? Commencez par ces conseils. Comment utiliser la communauté Guide pour les nouveaux membres
Parcourez les liens directs de la Communauté et profitez de contenus personnalisés en français