FWSM chassis query

[thetone69]

Hi folks,

is there a way of issuing a command to tell you what switch you are on when you are logged into the FWSM ie if switch name is SW1 and the FWSM is FWSM1. How would I know that I'm on SW1?

[j.docio]

I use the "show failover"... it will show you if you are on the "Primary" fwsm.

Regards.

[francisco_1]

i dont think you can!. might be wrong.

[Jon Marshall]

Without wishing to state the obvious we used to just name the FWSM so you could match it up with the switch ie.

switch = DC-BBP-F00-DS1

FWSM = DC-BBP-F00-DS1-FWSM1

etc..

Jon

[francisco_1]

extactly what we do.

in jon's example, we use

SW-DC-BBP-F00-DS1

FW-DC-BBP-F00-DS1

FW for the FWSM

SW for the SW hosting the FWSM..