Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings to everyone, i would like to ask ,which is the best way to backup the configuration of firewall firepower 1140 running an FMC v6.6.0.Thanks in advanced
hello to everyone, by mistake i disable the Management Interface and from then i am not able to login to the web interface of the device.could you help me to enable it again through command line, i connect to the device through a cable with a serial ...
hello to to everyone, as i am new in firepower 1140 device, i would to like to configure a static nat to the inside interface 192.168.1.1 translated to the public ip which is the outside interface through a pppoe connection (running vesion6.6.0).the ...
Hello to everyone, Recently we bought a firepower 1140 threat Defence and i am wondering if i am able to confirure an outside interface with PPPoE. i perfromed the initial configuration and also i dont know how to configure that. i am not able to ch...
i connect to the management interface and i login successfully.Great!!BUT the way that i logined to the device was from the inside interface where a laptop is connected.the inside network is 192.168.1.0 255.255.255.0 192.168.1.1so i connect to https:...
i am glad to hear that because i run this command before i wrote to community,Although the message that i received was "the https access list was changed successfully" i am not able to see the web interface of the device. is anything else that i have...
