Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am new for firewall, bought this ASA 5505-X and doing some initial setup. So far i defined management int which is UP/UP http server enabled, ssh and Http all required IPs to management but seems like i am missing something and all these settings c...
I am looking forward to have some real gear experience so after working a while on Packet Tracer I bought 3 cisco routers. One is 2901 and others are 1921s. 3 cisco layer 3 switches all of them 3560s. right now that's how i am connected all of them, ...
Hello All, I have got Three Cisco Routers and Three Cisco SwitchesOne router is 2901 gigabitTwo routers are 1921 gigabit All three switches are Cisco 3650 Catalyst version 2seriesall int on routers have been alloted with Ip addresses. Let's just sti...
I am connected to ASA through PC. My PC IP is 192.168.1.7 255.255.255.0 and is on WIFI. ****INT configuration m1/1**** Interface Management1/1 "management", is up, line protocol is upHardware is en_vtun rev00, BW 1000 Mbps, DLY 10 usecAuto-Duplex(Fu...
all routers have been configured. RIP is enabled and working on them. Thank youinstead of using console port how to configure multiple sessions on superputty so that i can work around on all routers and switches in one window.
