Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, very new to this and unfortunately in a position where I need to try and get some config working without having learned all the basics and core concepts yet. I'm using the ASDM for configuration. What I am trying to achieve - An internal IP addr...
Hi @Marvin Rhoads From what I can see, tracking a packet over the CLI returns what I should expect, see sanitised results below: # packet-tracer input inside tcp 192.168.16.54 1025 EXTERNAL_IP 22Phase: 1Type: ROUTE-LOOKUPSubtype: Resolve Egress Inte...
This is where I am at the moment (but not working successfully): Access rule - I've changed source to 'any' as I don't think this really matters. So any source heading to those 4 destinations can do so over ssh. Note - There are other rules to handl...
@Marvin Rhoads No, I would assume that isn't what I want (this will be my lack of current knowledge), there is no need for the private IP to be preserved as far as I am aware. Is this no-NAT because I've left the translated packets as 'original'? So ...
This is a packet trace of my local IP address > external IP address whereby I want to allow SSH. I'm still not getting any joy on the SSH to any of these servers.
Thanks for your reply. When you say "Access List", do you mean the "Access Rules" right at the top? Pretty sure you do but wanted to check. I've deleted my ACL and replaced it with a rule in Access Rules on the inside interface as so: You'll see thi...
