About Janne K.

Janne K. · 09-12-2024

I am having a strange problem with my AirOS 8540 WLC sometimes using the wrong DHCP proxy IP for one of my vlan interfaces.I have a ISE enabled SSID where i have set a dummy interface in the WLAN tab.Normaly this works flawless for all the networks.B...

Janne K. · 02-08-2024

Hi,Im currently on ISE 2.7 p10 and want to run the URT for 3.2It says to install on the secondary Administration node. But, our deployment of six nodes has:1 combined Primary PAN and secondary MnT,1 combined Secondary PAN and Primary MnT,4x PSNCan I ...

Janne K. · 01-04-2024

Is there a way to have dnac stop showing these banners and messages over and over again?Our installation is now a few month old, and I have been getting the "Start Tour" and the "Begin your journey" and all other kinds of reminders to enable this and...

Janne K. · 01-11-2023

Hello there,Im having a bit of trouble reinstalling/reimaging my first gen (DN1-HW-APL-U) DNAC with Release 2.3.3.5 I followed the guide from here I am able to boot from the USB and fill out the maglev Wizard, but after the wizard completes and and g...

Janne K. · 09-09-2022

I am thinking about turning on the "PEAP Session Resume" feature in ISE but have a few questions.I understand I can change the session timeout, but how long can a client actually ride on the cached sessions? Does ISE after a given amout of reauthenti...

Janne K. · 09-12-2024

Yes, the client associate and get authenticate correctly, and i can see in WLC that it is gettin the correct vlan information from ISE.but instead of the configured vlan DHCP Proxy IP i get the one from the Dummy interface configured on the wlan inte...

Janne K. · 09-12-2024

Im not sure i understand what you mean..I should add to it that the vlan is pretty big with ~ 5000 simultaneous BYOD clients

Janne K. · 02-12-2024

Thanks for the info, it is very straight forward and easy to use.besides the fact that the estimated time for upgrade is 917 minutes.Edit after upgrade:All went surprisingly smooth. We did everything through the GUI.The only strange thing was that th...

Janne K. · 01-09-2024

I was getting these messages every day in firefox. Just switched over to edge, but so far the same behaviour.

Janne K. · 01-12-2023

OK... so, I feel a bit stupid but also a bit annoyed about this one.I tried going through it again from the top carefully reading the guide, and came to this note:"Do not use the Rufus utility to burn the Cisco DNA Center ISO image. Use only Etcher, ...

Member Since	‎09-24-2020 01:54 AM
Date Last Visited	‎09-26-2024 01:22 AM
Posts	31
Total Helpful Votes Received	36

User Statistics

User Activity

8540 DHCP problems

URT on node with multiple personas?

disable banners and Start Tour messages

Problem re-installing/imaging DNAC

PEAP Session Resume questions

Re: 8540 DHCP problems

Re: 8540 DHCP problems

Re: URT on node with multiple personas?

Re: disable banners and Start Tour messages

Re: Problem re-installing/imaging DNAC