Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyoneI need to inspect traffic flowing on a L2 segment of my networkI’m using a FTD 1010 with 6.5 softwareI’m wondering if it’s best to use a bridge group or an inline setI didn’t find any clear statement from Cisco about choosing between bridg...
Hi everyone I need a little help with NAT on FTDI'v been searching since yesterday but I had no luck finding some infosWhat is the correct way to populate the configuration form for this scenario? Please see attached imagesFigure 8 Static NAT with P...
Hi everyone,I’m having a strange issue with a new FirePower Threat defense installation My Company has an MPLS that connect all the branch offices and an Internet connection for Internet Navigation The FTD is configured in routed mode just to protect...
Hi Marius thank you for the replyBridge group can be used also in transparent mode since ver 6.2My practical question is: should I use a bridge group or an inline set to inspect and secure traffic? I have a scenario where I'm forced to install the fi...
Hi @Rob Ingram Thank you for the reply.I’ve been studying the documentation since last month.Now I re-read carefully the configuration guide and I got the point.If I’m not wrong, in-line sets are IPS passive online interfaces and can not do some typi...
