Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I did all the configuration of multipod and I will do some 3x the leafs and spines.Here is some information:I'm making my second Fabric, so I'm putting it as Fabric ID: 2I got to the part where I discover the POD2 Spines, however, I configure the IPN...
I will do everything in POD2, but without success.I checked the IPs of the OSPF interfaces and the IPN were changed. After fixing the IPs, the Multipod closed.Thank you for your help!
Hello RobertNow I configured it with Fabric ID: 1, but I have the same problem.I configured the Multipod, registered the POD2 Spines, I see that the APIC caused the IPs as "Reserved" and I checked the IPL LLDP that is directly connected with the POD2...