Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all !As a result of recent DDOS increase, I am fedup of manually blocking IP addresses attacking on Port 80 of our servers. Is it possible to limit the number of connections on a Port or from an IP address on ASA5510 ?Regards,Murtaza Jamali
Hello All,Our servers have recently been facing quite heavy targetted DDoS attacks initiated through Proxy shields which is causing us huge trouble. I do not think I can find a better solution for this than a hardware device and by the time I check t...
Hello all,I just wanted to know a basic answer I guess... does the ASA5510 only act as a routing device or can I deploy it within a network already having a router as a gateway?I already have a network setup with around 100 hosts (out of 254). I have...
Hello,I have configured an ASA 5510 at our data center. The problem I am facing is that in the network range of 0 to 255 there are servers with /24 masking and these are already routed by the router. I want to deploy the ASA firewall only to 6 of the...
I have just configured the firewall with all the standard configuration but I can not gain SSH access. I have attached the running-config below, can someone please let me know what am I missing. I have configured the SSH exactly as stated at :http://...
Hello Sushil,You can filter the incoming traffic based on Ports you require by applying ACL to the outside interface of the ASA. Create the rules to allow specific Ports to specific or all hosts inside the ASA and all the other traffic will be denied...
Hi Brian,As far as what I think, the ASA also acts as a routing device so it can not be configured after an already routed network consisting hosts with global IP addresses. If the firewall is to be deployed, it has to be made as the gateway for the ...
Ok, we have around 200 servers on the network 31.0 - 31.255 at the DC. One of our clients having 6 servers within needs his servers to be secured by ASA5510 with ACLs and Crypto tunnels. I have configured the firewall but I was looking for a way to d...
Ok, that means what I am thinking of doing is not possible on the same network within a single switch. What about Passive and Active firewall, can I achieve that if the firewall is mad Passive ?Regards
