Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Some TCP traffic (ssh and Telnet sessions) get reset when allowed for some minutes through our PIX 520 image 6.0(2). Going though Cisco bug sheet, I found out this problem belongs to bug: CSCdr11711 which should be resolved by upgrading to 5.0(1) or...
I have configured failover PIX520 with public addresses for both inside, outside and failover. Also with not natting for the addresses. But I have not configure static mapping ie static (inside, outside).Please, can this be the problem?
I would suggest the following:-)1) On the HQ add redis static/connected on the eigrp so the LAN section is ejected.2) Manually [for test purposes] add static route entry on the server to the HQ route 3) Traceroute from 1751 to the server behind 2625....
Please, find attached my log and config<<< Log from ops.noc.colt.net started November 20, 2002, 14:58:17 >>> wr t Building configuration...: Saved:PIX Version 6...
