Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am pulling my hair out and hoping someone can help provide some guidance. Following the "VMX in Azure" deployment guide, I deployed a VMX to an Azure Hub Vnet and it checked into the Meraki Dashboard and AutoVPN is up, and from on premise I ...
Hi,We're having some trouble with a Meraki AnyConnect deployment and wanted to check with the community to see if anyone else has encountered this random issue. The deployment is MX 250 running firmware 18.107.2 with authentication to DUO via SAML. O...
HiI'm stumped so wanted to reach out to the community in hopes that someone has some wisdom or guidance to share.I'm testing AnyConnect VPN with Certificate Authentication. This is on a MX250 running v16.16 firmware and AnyConnect Client v4.10.05085 ...
Thanks! That was definitely part of the problem. Adding the route to the spoke VNet and enabling VPN was absolutely necessary.As for the other part of the problem, there was an Azure User Defined Route table linked to the VMX's LAN subnet in the hub...
Hi DawieKabouter,Thanks for reaching out again and best wishes to you as well!Since we last connected, I was ultimately able to open a collaborative support case between Cisco, Meraki, and DUO to hopefully get to the bottom of this. With that said, I...
Hi DawieKabouter,We ran into the issue today and your work-around appeared to work as you described!We logged into the PC as an administrator and established the VPN without any issues. We then disconnected the VPN and logged back into the PC as the...
Thanks for your response. I'll relay the "AnyConnect as admin" thing to my team so they can test it the next time this comes up and will post some feedback with our findings.
