Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a PIX 501 with a corrupted configuration. During the flash load, it fails with a checksum error and then starts the reload all over again, etc, etc, etc...I have booted to the monitor mode and have attempted to upload a new configuration using...
I was just thinking about my situation. Is it my configuration that is bad (as I thought) or is it the firmware that is bad? I have been trying to upload the configuration.
I have that issue with DHCP remotes. No way for us to know what their outside address will be. They have to open the tunnel. I think I may have stumbled upon a possible solution by using the NTP protocol to work off a server at my HQ. This way, tha...
