Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
We are implementing PIM Sparse-Mode from 1 LAN over an MPLS WAN to another LAN - to stream audio. When using a tool to test broadcaster/listener traffic using a multicast group 239.0.100.X the tests constantly fail between sender and receive...
Hi All,
I have a task to create some rules for a Firewall that is in production and currently does not have any rules on the Firewall.
I've managed to look onto the Firewall and see the top protocols going through the Firewall and generic protocols...
Hi, Yes the two switches do inter operate together. I’ve configured a L2 trunk between both vendors in the past. HP are decent switches and much cheaper than the other top vendors.
Hi Julian, VTEP's are the devices that do the VXLAN encap/decap and are the leafs that the VXLAN tunnels form between. If you want to use 9500 as VTEP's best to use them as the leaf switches and use different switches as spines. HTH.Ben
Hi,
Yes you can ping the RP from the sending router and you can see a PIM neighbour adjacency also. You can also see that all 3 devices know the RP of the network via BSR.
Yes it is possible. But that depends whether you have a Layer 2 or a Layer 3 switch. For example a Cisco 2950 switch is Layer 2 so cannot use 'routed ports'. A Cisco 3850 switch for example is a Layer 3 capable so can use layer 3 functions. Under an ...
