Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a PIX 525E with IOS 6.3.We've just recently installed a point-to-point T1 that is terminated with 2 Cisco 2610XM routers with VWIC-1MFT-T1 cards (IOS = 12.2).The two networks at the remote end of the T1 connection can access all resources at t...
I found the problem while double checking the access-lists.Typically I don't setup "any" rules but I was pressed for time on this project and took the quick and easy way out and created a NoNat access-list entry for the two new networks with a destin...
No entries in the syslog about NAT failure.There aren't even any entries for "IP_ADDRESS accessed URL ..." but I know that the routing is working correctly because a host at the remote site can ping the inside interface of the pix and vice-versa. How...
The physical layout is:Internet Router -> Pix -> Internal Core Router -> Router to Remote Networks.There is no access-list that would block Internet traffic from the remote networks and the PIX is aware of the two remote networks.The router connected...
